Yose power 350W kit capable of open software?

Bartbart

1 µW
Joined
Nov 27, 2022
Messages
3
Hi there.
I have a Yose power 350w kit with build in Liushi controller in battery base capable of 18A with dashi c500 lcd. Just wondering if that set is capable of programing with open software mainly because of how it actually works, witch is on off by pas up to certain speeds and I'm relly hate it so much. I have an stlink v2 along with some other programmers. Only thing what I'm really want to change is that pas behaviour to torque simulation one.

Yose power 350w kit. https://yosepower.com/products/36v...e-with-36v13ah-battery?variant=39530723770503
 

Attachments

  • 87D17A45-74D9-4A49-91D5-794D360F4D6B.jpeg
    87D17A45-74D9-4A49-91D5-794D360F4D6B.jpeg
    1.6 MB · Views: 118
Not yet, but work is in progress :D
As the processor is a weak STM32F031, it will be sixstep commutation only. The pinout of the processor is the same as on the STM32F103 from the FOC controllers, but the pin functions are mostly different.

regards
stancecoke
 
Ok. Thanks for quick reply.
I move to KT for now then until that Lishui will be flashable :)
Just want to keep stealth look of the bike without separate controller in pouch, so KT should be simple swap and smaller Lcd4 only as +. And as far as I know reading the manual drive mode can be changed on stock firmware.
 
I don't really need to see anything except of speed and battery. So lcd4 even is bit to big to my liking :)
 
Back
Top