So yesterday after getting back form a rip on a few of my bikes, me and a friend were messing around with his high speed camera and making arcs using a high voltage Neon sign transformer, some silicone wire with ends stranded apart for extra effect....
All of a sudden, my KMX trike ( 100v X5 on lipo ) that was powered up but had been sitting there for a while, about 4ft away, suddenly came to life.. ripped thru the garage, pinned itself against my fatbike and burned rubber while i ran like a madman to shut it down.... ( back wheel burned a nice skid mark into my plastic covered floor lol )
I propped the wheel off the ground and tested it again, sure as shit.. she's going until i disconnect the throttle.... so i replaced it and the trike runs again properly... but how is this possible ?
anyone ?
All of a sudden, my KMX trike ( 100v X5 on lipo ) that was powered up but had been sitting there for a while, about 4ft away, suddenly came to life.. ripped thru the garage, pinned itself against my fatbike and burned rubber while i ran like a madman to shut it down.... ( back wheel burned a nice skid mark into my plastic covered floor lol )
I propped the wheel off the ground and tested it again, sure as shit.. she's going until i disconnect the throttle.... so i replaced it and the trike runs again properly... but how is this possible ?
anyone ?