Minexplorer
100 µW
- Joined
- Jan 19, 2018
- Messages
- 7
Hi.Im wondering if anyone can shed some light on this.Ive fitted a new controller that has a connector identified as three speed.All i have read says unused the bike will operate at a med speed. Joining the ground to one of the others will reduce the speed and to the other give a higher speed. However when testing with the wheel raised off the ground, i found BOTH reduced speed of the wheel considerably.Max rpm was if left unused. One wire is black ,marked GND on circuit board.The other two ,green/white and blue/white marked H1,H2 on the board.Thanks