Question about my Ananda brushless controller

Greetings from the Netherlands guys,

Few days ago there was rain & I left my bike outside under the rain. luckily the motor and the controller are fine.
the bike now goes on but it stays on & I cant change the level it stays on 3 (I have 5 levels).
I did order Display KT-LCD8H (it hasn't arrived yet) but should I worry about mixing the wires?
I have a connector & all but its seems different on the diagram than on the bike that I have.
please be kind to a newbie. see the attached photos.
Please advise.

Displays usually only work with the controllers they were sold with. Unless you knew Ananda works with KT, it seems like a gamble to me.

This is your original picture, with shadows lifted to see that the connector is different, being a six position connector, and the wire colors are in the wrong position for a KT display. Is there a second black wire between green and blue?

You should verify that red is battery voltage, and black is ground, before you start trying to match colors, but I think it will be a waste of time.

I did change the controller & the LCD.
Now everything is working fine. I just need new battery lol :lol: