Hi all!
Is it worth/beneficial to, for example, cut the phase wires on a qs273 motor, leaving about 15cm sticking out of the motor then replacing the rest of the long phase wires that were cut with 6awg wire on each phase and crimping everything tight??
Its almost impossible to fit thicker wire through the axle so this seems like the only option at the moment.
Or would the gains be minimal or not worth the effort?
Ill be running over 100V and pretty high amps when in bursts.
Thanks!
Is it worth/beneficial to, for example, cut the phase wires on a qs273 motor, leaving about 15cm sticking out of the motor then replacing the rest of the long phase wires that were cut with 6awg wire on each phase and crimping everything tight??
Its almost impossible to fit thicker wire through the axle so this seems like the only option at the moment.
Or would the gains be minimal or not worth the effort?
Ill be running over 100V and pretty high amps when in bursts.
Thanks!