Ownzies
1 mW
I'm planning my first build and I'm pretty confused here. The diagram for my hub motor (shown in photos below) says it has 10mm flats. I assume these go into 10mm flat holes on my dropouts. My dropouts seem to have 12mm circular holes. Currently has bolt-through axle. It is a old Norco A-Line/Atomik. Am I just not understanding this correctly, or will a conversion kit not work with these dropouts?
I will be spacing it out quite a bit to accommodate 150mm dropout, so I'm not sure if I'd have the space needed to use a torque plate.
Here are some photos. https://imgur.com/a/VtTMWUB
Thanks
I will be spacing it out quite a bit to accommodate 150mm dropout, so I'm not sure if I'd have the space needed to use a torque plate.
Here are some photos. https://imgur.com/a/VtTMWUB
Thanks