Dear friends,
I've been trying for days to get my Phaserunner / Baserunner to run with an Geared Front HUB Aikema AKM-100SX, but it didnt run smooth. Now I'am
think, there are some parameters wrong, the autotune function doesnt help. Now I have no glue anymore :-(
Here are some technicals specs of my AKM 100SX Front HUB Motor:
https://www.aikema.com.cn/en/product/aikema-100SX-front-hub-motor-ebike-conversion-kit.html
- Gear Ratio 1:12.6 (perhaps also Gear Ratio 1:11,2 (not shure, difference between Rear and front motor :-()
- 8 Poles
- ca. 240RPM / 36V (maybe a little bit faster)
maybe someone has already used an AKM / Cute100 / Q100SX Hub Motor with similar specifications on a Phaserunner / Baserunner ASI BAC Controller?
To minimize Problems, i set Phaserunner Suite parameters to Hall Sensor only. With Parameters in screenshot the 100SX runs, but not from scratch, i must turn the wheel a little bit and at the beginning i have some rattle vibrations on my fork.
best greetings,
marc
I've been trying for days to get my Phaserunner / Baserunner to run with an Geared Front HUB Aikema AKM-100SX, but it didnt run smooth. Now I'am
think, there are some parameters wrong, the autotune function doesnt help. Now I have no glue anymore :-(
Here are some technicals specs of my AKM 100SX Front HUB Motor:
https://www.aikema.com.cn/en/product/aikema-100SX-front-hub-motor-ebike-conversion-kit.html
- Gear Ratio 1:12.6 (perhaps also Gear Ratio 1:11,2 (not shure, difference between Rear and front motor :-()
- 8 Poles
- ca. 240RPM / 36V (maybe a little bit faster)
maybe someone has already used an AKM / Cute100 / Q100SX Hub Motor with similar specifications on a Phaserunner / Baserunner ASI BAC Controller?
To minimize Problems, i set Phaserunner Suite parameters to Hall Sensor only. With Parameters in screenshot the 100SX runs, but not from scratch, i must turn the wheel a little bit and at the beginning i have some rattle vibrations on my fork.
best greetings,
marc