Converting 8 hall sensor values to 6

sdobbie

100 W
Joined
Dec 14, 2013
Messages
137
Location
Fife Scotland
I have now moved on to vesc from the KT controller and wanted to give the kt controller away to a friend all set up and ready to go on a bike. I measured the hall angles in the vesc tool and was wondering how I convert them to the values needed in the osec configurator?
This is what the vesc tool measures
hallset2.png

This is what the osec tool needs. Both system accept 0 to 255 values
hallset3.png
 
I don't think VESC uses 0 to 255. I think it's 0 to 200 and the ones with 255 are the not valid hall states.

So you'll need to do some translating, and it's not clear to me at least what order the kunteng wants them in
 
Does your motor have 60 degree hall sensors? Looks from the VESC output as if it does. In which case... Does the kt/osec even support it?
 
I haven't a clue what order it is either, I tried copying the angles into the kt software but the motor didn't run at all. The vesc failed a few days ago too so I am back to the KT controller again.
 
Back
Top