Can I than ask what exactly is the procedure?
This is as was posted above:
Could be self study (join 2 white wires with matching connections)
connect motor and hall wires, matching colors.
connect power.
you don't need the throttle yet.
identify the on / off wire (lock, should be red), connect to positive.
motor will run and self study. if in reverse direction, disconnect and reconnect white wires.
If it runs properly disconnect white wires.
Now you can use the throttle
and this is different instructions found on the internet:
1. Make sure your battery / power supply can deliver enough power.;
2. Plug in the Black and Red power line;
3. Engage self-study wire;
4. Connect the key wire (Orange) to +V and the motor should start spinning;
5. Let it spin for awhile for the controller to learn the phase angle of the Hall probes;
6. Disconnect self-study wire and the motor should stop, DO NOT ramp up throttle at this stage as it will make the controller unlearn step 5;
7. Disengage Key to let the controller save the configuration, DO NOT disconnect the Power wires!;
8. Reconnect the Key wire, and self learning is done, motor should now respond to throttle command.;
9. Configuration is now permanently stored, power cable can now be unplugged without erasing the self-learned configuration.;
10. Enjoy!
So what exactly are the steps? thank you!