Cheap FOCer 2 kits (35A 12s VESC6 based design) CURRENTLY SOLD OUT

Time to sell some Cheap FOCER 2 V1.0's

For more details here is the development thread for this VESC6 compatible electronic speed controller. It was developed buy a member here.

https://endless-sphere.com/forums/viewtopic.php?f=30&t=103465

https://forum.esk8.news/t/cheap-focer-2-open-source-low-cost-vesc-6-based-esc-v0-9-release-beta-testing-ongoing/

All boards are partly assembled (All SMT parts soldered) Firmware is loaded and checked for any faults. No IMU's included.

I am located in Ontario Canada but will ship to the US as well.

Included in the price is a $5 per board donation to @shaman who made this happen.

Shipping will be Canada post expedited parcel or USPS small packet. Should be under $20 shipped anywhere in North America. Order two to save on shipping.

No matter what some soldering will be required this is a DIY project. If you really need me to solder leads/connectors for you send me a DM and we can figure something out.

**No through hole DIY kit**
**Tested CFOC2 board without through hole components soldered**:
**Price ($45 USD $60 CAD)**:



**All components soldered DIY kit**
**Attach the leads of your choice and a heatsink and go**:
**Price ($56 USD $75 CAD)**:







**All components soldered DIY kit + heatsink**
**Attach the leads of your choice and go**:
**Price ($63 USD $85 CAD)**:

Still have a few of these left.

Do you still have any?

I do and plan on ordering more once these are sold.

Do we have to order the preassembled kit to get the picture of samuel jackson on the back?

JK, looks pretty neat. May be beyond my skill level as my soldering as about as bad as what you see in the worst of Chinese controllers but ordering a couple may be a good way to get some practice and end up with something cool at the end

Manbeer said:

Do we have to order the preassembled kit to get the picture of samuel jackson on the back?

Click to expand...

Shaman on here is the one who did the design and the SLJ artwork. https://endless-sphere.com/forums/memberlist.php?mode=viewprofile&u=62507

It is actually pretty good practice for hand soldering a combo of through hole and SMD components.

Sold the last one.

Going to order another batch once JLCPCB has all the parts in stock. Might be a while with the current chip shortages.

anyone manage to find the necessary parts to make more? @helno ?

diy_nikola said:

anyone manage to find the necessary parts to make more? @helno ?

Click to expand...

Unfortunately I have not been able to get more boards made. Just tried today to get some made but the various parts shortages are keeping me from ordering.

Not much point in making them if I have to source parts for much higher than normal prices and SMD solder them myself.