Custom USA made hubsink heatsinks for any diameter hub motor

$40 for two heatsinks that are each 1"x0.5" in size with 0.093" thick walls.

Just let me know the diameter of the hub you want to put them on.

Each pair is custom cut and non refundable.

There will be a slight gap between the start and end of each one which allows the screw to be tightened down so they are nice and snug.

shipping will be a flat $8 rate anywhere in the continental USA.
If you are in another country figgure $20-40 for shipping approximately.

Photos below show a 4.5" diameter My1018 motor with 2 heat sinks attached to it.

I'll also be stocking up on some ferrofluid and be selling that for about $1.50/ml.
prefer payment via credit card on my website:
https://www.metalmaslow.com/product/motor-heat-sink-hubsink

Also can make the hubsink out of
0.75"x1.5" Tube with 1/8" thick walls.
This would be a single heat sink and
not a pair of heat sinks. This is closer
to the original hubsink specs see below

first order custom made for dd45 motor!

Can work with this on the picture?

I don't think so because the rim is attached to the motor and there is a big 50mm gap beween the two. It will only fork for direct hub motrs, not motors with integrated rims. sorry.