Phaserunner stops wheel moving?

Joined
Jan 9, 2019
Messages
60
Location
Toronto
Hello everyone, so my phaserunner, newer version, brand new. Autotuned to my crystalyte 3540 and ca3. Autotune successfull.

But wheel doesn’t allow movement without throttle. Just kinda stops it. Both directions
I auto tuned it to my Gmac same set up and it did the same....
 
goatman said:
have you set your ca3 to the 3540

So yes its set to 23 poles but because im running the system dual motor, im supposedly supposed to set Rshunt value to 0.5 but when i try to do that it automatically jumps to 0.76....

im using a grin splitter between two Phaserunners. when i hit the throttle or move pedals to test PAS the Gmac moves great and the Crystalyte stutters for a second and then rolles forward only slightly just the electronic freewheeling it seems is allowing it to go a bit or just the momentun of the stutter.
 
crystalite has 23 poles
gmac has 80

ca3 splitter
you have 1 ca3
i think your problem is 2 different motors on 1-ca3 but i really dont know

i wonder what the guy in victoria did, he has a geared hub upfront and a dd on the rear
tigcross
https://endless-sphere.com/forums/viewtopic.php?f=6&t=100348&start=25#p1622142
 
Matteo's Mobile Bicycle Repair said:
So yes its set to 23 poles but because im running the system dual motor, im supposedly supposed to set Rshunt value to 0.5 but when i try to do that it automatically jumps to 0.76....
You have to set the CA to high range mode to use less than .75milliohm shunts.
 
Back
Top