Good day Troubleshooters,
I have a brand new 48v rear direct drive 1000w hub motor, new KT36/48ZWSLR-ff01 controller and new KT-LCD5 display.
This is my second ebike conversion. I hooked every thing up including fully charged 48v20ah battery and when there is no load, nothing happens at any throttle position until I touch the wheel then there is a loud growl at the beginning, and it will go to 50kmh easily.
When I took it outside to test it (under load), there is a loud growl and very little power, it will only go about 10 kmh at the most.
The settings for the LCD5 I put in are: G1- 72, G2- 23", G3- km. P1- 46, P2= 1, P3- 0, P4-0,P5- 17. C1-02, C2-0, C3-1, C4-2, C5-10, C6-5, C7-1, C8-0, C9-0, C10-n, C11-0, C12-4, C13-0, C14-2. Please help, I just know it's in these settings.
I have a brand new 48v rear direct drive 1000w hub motor, new KT36/48ZWSLR-ff01 controller and new KT-LCD5 display.
This is my second ebike conversion. I hooked every thing up including fully charged 48v20ah battery and when there is no load, nothing happens at any throttle position until I touch the wheel then there is a loud growl at the beginning, and it will go to 50kmh easily.
When I took it outside to test it (under load), there is a loud growl and very little power, it will only go about 10 kmh at the most.
The settings for the LCD5 I put in are: G1- 72, G2- 23", G3- km. P1- 46, P2= 1, P3- 0, P4-0,P5- 17. C1-02, C2-0, C3-1, C4-2, C5-10, C6-5, C7-1, C8-0, C9-0, C10-n, C11-0, C12-4, C13-0, C14-2. Please help, I just know it's in these settings.