Jil
1 kW
Hi !
I have installed a torque sensor ERider on my Krampus, and a temperature cable.
Then I have updated my Cycle Analyst from v 3.14 to v3.15 (CA3-15b3_firmware.cahex).
Everything is working well, apart from the speedometer, which displays 0 kph most of the time, and sometimes bursts to inconsistent values, well below the real speed. Before the modification, it was working well (with a standard PAS).
Some thoughts about the possible reason ? Setup issue (Cycle Analyst or Phaserunner), or cable/sensor out of order ?
Short video :
https://youtu.be/WGVwHESwpic
I have installed a torque sensor ERider on my Krampus, and a temperature cable.
Then I have updated my Cycle Analyst from v 3.14 to v3.15 (CA3-15b3_firmware.cahex).
Everything is working well, apart from the speedometer, which displays 0 kph most of the time, and sometimes bursts to inconsistent values, well below the real speed. Before the modification, it was working well (with a standard PAS).
Some thoughts about the possible reason ? Setup issue (Cycle Analyst or Phaserunner), or cable/sensor out of order ?
Short video :
https://youtu.be/WGVwHESwpic