Lakepirate
1 µW
- Joined
- Dec 5, 2021
- Messages
- 2
Hi.
I need some help with a rebuild. I bought a Q100c kit from BMS battery years ago. Installed and ran it for years and then the motor finally gave up. I bought a new Q100c motor and installed worked fine for around 500 miles and then lost most power. It would only do like 2mph at full throttle. So I started checking wires and battery connections and found no faulty stuff. I suspected the controller and took it out and visually did not see anything fried or looking bad. Lost at that point I started with a new controller. The kit was a 36v 350 watt bottle battery kit that included the S06p controller and LCD1 display. The new controller I got was the S06s with the LCD3 display. No luck with that. I got a new throttle, no luck there. So the motor must have failed, got a new one and still no luck getting it to turn. So basically I have replaced every part and wire. The display lights up and shows a full battery and all the normal stuff, but when I turn the throttle I get error code "03 info". I believe this is indicating a problem in the motor or the wiring from the controller to the motor which are brand new and hooked up just as before.
Will the Q100c not run with the S06s controller?
Is there a setting adjustment with the controller/display that I need to change?
The PAS in not hooked up and never was and I unhooked the throttle and tried the walk mode with same error code.
What testing should I try?
Thank you for any info!
I need some help with a rebuild. I bought a Q100c kit from BMS battery years ago. Installed and ran it for years and then the motor finally gave up. I bought a new Q100c motor and installed worked fine for around 500 miles and then lost most power. It would only do like 2mph at full throttle. So I started checking wires and battery connections and found no faulty stuff. I suspected the controller and took it out and visually did not see anything fried or looking bad. Lost at that point I started with a new controller. The kit was a 36v 350 watt bottle battery kit that included the S06p controller and LCD1 display. The new controller I got was the S06s with the LCD3 display. No luck with that. I got a new throttle, no luck there. So the motor must have failed, got a new one and still no luck getting it to turn. So basically I have replaced every part and wire. The display lights up and shows a full battery and all the normal stuff, but when I turn the throttle I get error code "03 info". I believe this is indicating a problem in the motor or the wiring from the controller to the motor which are brand new and hooked up just as before.
Will the Q100c not run with the S06s controller?
Is there a setting adjustment with the controller/display that I need to change?
The PAS in not hooked up and never was and I unhooked the throttle and tried the walk mode with same error code.
What testing should I try?
Thank you for any info!