I got my new 36/48v 350w sensored and sensorless controller today. After unboxing it i connected it with hub motor 36v after that i tested with 36v 350w hub motor everything was fine motor was running normally but when i tested it with load problem started with sensors connected motor i accelerated slowly and motor was working as expected low noise but after crossing 23km/h speed i started feeling slight jerky i.e. my motor was accelerating and stopping and accelerating again and again. After disconnecting sensors motor worked with some noise but when i ride it stopped accelerating after touching 26km/h seed and didn't respond after Reaccelerating so i turned it off and on and this same problem occurred when ever i touch 26km/h
Battery voltage were 46v.
I possess fair knowledge of electronics
Battery voltage were 46v.
I possess fair knowledge of electronics