I am redoing my bike with a new hub motor and controller (35A), KTLCD8H...
Went through and tried to match all the settings in the controller to a RAD which is the closest. But then tried everything I could find in the documentation that might turn the throttle on or off.
After quite a bit of fiddling walk mode works perfectly in the right direction, nice and smooth, reports 24 watts. Brake interrupts seem to be working.
But I have no throttle, not sure if PAS Is working. If I set it to 5 I can get the throttle icon to appear on the screen intermittently but it doesn't appear to be feeding in power as I pedal with the tire off the ground.
I have tried with only throttle connected. Went through all the hall and phase combos, etc... Still no throttle and no PAS.
Is it possible to have an incompatible throttle or PAS sensor? This bike was working until the tiny controller it came with quit. So thought a good time to upgrade.
Went through and tried to match all the settings in the controller to a RAD which is the closest. But then tried everything I could find in the documentation that might turn the throttle on or off.
After quite a bit of fiddling walk mode works perfectly in the right direction, nice and smooth, reports 24 watts. Brake interrupts seem to be working.
But I have no throttle, not sure if PAS Is working. If I set it to 5 I can get the throttle icon to appear on the screen intermittently but it doesn't appear to be feeding in power as I pedal with the tire off the ground.
I have tried with only throttle connected. Went through all the hall and phase combos, etc... Still no throttle and no PAS.
Is it possible to have an incompatible throttle or PAS sensor? This bike was working until the tiny controller it came with quit. So thought a good time to upgrade.