pasta
100 µW
I would like to get a 063770-SL Mark II (sensorless) Lyen controller and a Cycle Analyst v2.24 (I know they are both a few years old...) to work with my Crystalyte 5303 hub motor (with hall sensor connector), without success so far.
Anyone knows if this combination is known to work?
I have tried the following: I have programmed the controller (see below the contents of the configuration file) and connected to it: a 36V battery, the Cycle Analyst, the three phase leads of the motor, a PAS and a three-step throttle (with "1", "2" or "3"-full throttle). Depending on the throttle setting and without turning the motor, I observe that the CA measures a different voltage (35V, 30V and 35V).
When I push the pedals, then the wheel turns but the motor does not engage, i.e. it feels like there is no motor support. At the same time, the voltage measured by the CA goes further down, to wherever I set the low-voltage cutoff. The CA keeps showing a current of ~0A.
Any ideas? Controller broken? (I know I should have connected a fuse... :\ )
Anyone who has experience with this setup and can give me hints?
Thanks in advance!
---
profile.asv:
1:EB306
40
20.0
24.0
1.0
99
0:Switch 3Spd X1 X2
100
100
100
1.0
15.0
1:Only Fake Indicate
0:Comm VCC
0:
35
55
0:Low
0:None
1:False
03
0:Speed1
100
2:Compatible
30
0:No
Anyone knows if this combination is known to work?
I have tried the following: I have programmed the controller (see below the contents of the configuration file) and connected to it: a 36V battery, the Cycle Analyst, the three phase leads of the motor, a PAS and a three-step throttle (with "1", "2" or "3"-full throttle). Depending on the throttle setting and without turning the motor, I observe that the CA measures a different voltage (35V, 30V and 35V).
When I push the pedals, then the wheel turns but the motor does not engage, i.e. it feels like there is no motor support. At the same time, the voltage measured by the CA goes further down, to wherever I set the low-voltage cutoff. The CA keeps showing a current of ~0A.
Any ideas? Controller broken? (I know I should have connected a fuse... :\ )
Anyone who has experience with this setup and can give me hints?
Thanks in advance!
---
profile.asv:
1:EB306
40
20.0
24.0
1.0
99
0:Switch 3Spd X1 X2
100
100
100
1.0
15.0
1:Only Fake Indicate
0:Comm VCC
0:
35
55
0:Low
0:None
1:False
03
0:Speed1
100
2:Compatible
30
0:No