Hey everyone! I was just riding home from work when a passing truck absolutely soaked me with a puddle.
A couple seconds later the rest hub motor started skipping and stuttering, the ktLCD threw an error 3 and then the backlight on the LCD started to fade in and out...
I was 30km from home still so didn't have much of a choice but to try and get it running so I Powered everything down, unplugged and dried all connections and then powered it back up.
On starting it back up the hall sensors stutter for a couple seconds and then the motor roars to life, if I try and use the throttle or PAS from a stand still it'll start stuttering before finally roaring to life again.
I made it the 30km home ok... The LCD3 threw and error 3 once more on the way.
I've been home for 20 minutes now and just started it up one more time and there wasn't and stuttering this time working as normal but I'm a little bit nervous... Not sure where I should be looking for water ingress...
Any help would be greatly appreciated!!
A couple seconds later the rest hub motor started skipping and stuttering, the ktLCD threw an error 3 and then the backlight on the LCD started to fade in and out...
I was 30km from home still so didn't have much of a choice but to try and get it running so I Powered everything down, unplugged and dried all connections and then powered it back up.
On starting it back up the hall sensors stutter for a couple seconds and then the motor roars to life, if I try and use the throttle or PAS from a stand still it'll start stuttering before finally roaring to life again.
I made it the 30km home ok... The LCD3 threw and error 3 once more on the way.
I've been home for 20 minutes now and just started it up one more time and there wasn't and stuttering this time working as normal but I'm a little bit nervous... Not sure where I should be looking for water ingress...
Any help would be greatly appreciated!!