Okay, so in our ebike section, we have a lot of different non-hub motor drives
The ideal work flow:
I create a tool that allows us to easily mark and move threads, supplanting the need for giving access to the moderator control panel.
I create a section for 'Ebike other drives'.
I create a section for 'Ebike hub motor drives'.
I create a section for 'Ebike rear chain drives'.
Work phases:
1) Volunteer moves all non-mid drives ( friction drive, etc ) from 'EBike Non-hub Motor Drives' to 'Ebike other drives'.
2) Volunteer scans 'Ebike Non-hub Motor drives' for hub motor threads and moves them to 'Ebike hub motor drives'.
3) Volunteer scans 'Ebike Non-hub Motor drives' for rear chain threads and moves them to 'Ebike rear chain drives'.
4) I rename 'Ebike Non-hub Motor drives' to 'Ebike mid drives'.
And then we have:
'Ebike other drives'
'Ebike hub motor drives'
'Ebike mid drives'
'Ebike rear chain drives'
This is probably 16 hours of work in total.
You could volunteer to do just one phase, which would amount to 5 hours of work, or a sunday/saturday. Or the whole enchilada.
I promise the tool used to mark these threads will be as convenient to use as possible and show a small snippet of the original post and post title so you can easily do this job on all one screen. 100% accuracy is not required. Just read the first post and make the decision from there. We can clean up the mess created by topics that have changed from one subject to another later.
If you'd like to volunteer, let me know if you want to just take one phase of the project, or the entire enchilada.
The ideal work flow:
I create a tool that allows us to easily mark and move threads, supplanting the need for giving access to the moderator control panel.
I create a section for 'Ebike other drives'.
I create a section for 'Ebike hub motor drives'.
I create a section for 'Ebike rear chain drives'.
Work phases:
1) Volunteer moves all non-mid drives ( friction drive, etc ) from 'EBike Non-hub Motor Drives' to 'Ebike other drives'.
2) Volunteer scans 'Ebike Non-hub Motor drives' for hub motor threads and moves them to 'Ebike hub motor drives'.
3) Volunteer scans 'Ebike Non-hub Motor drives' for rear chain threads and moves them to 'Ebike rear chain drives'.
4) I rename 'Ebike Non-hub Motor drives' to 'Ebike mid drives'.
And then we have:
'Ebike other drives'
'Ebike hub motor drives'
'Ebike mid drives'
'Ebike rear chain drives'
This is probably 16 hours of work in total.
You could volunteer to do just one phase, which would amount to 5 hours of work, or a sunday/saturday. Or the whole enchilada.
I promise the tool used to mark these threads will be as convenient to use as possible and show a small snippet of the original post and post title so you can easily do this job on all one screen. 100% accuracy is not required. Just read the first post and make the decision from there. We can clean up the mess created by topics that have changed from one subject to another later.
If you'd like to volunteer, let me know if you want to just take one phase of the project, or the entire enchilada.