I'm just about to put a tyre on my new 12" QS hub motor and have a problem with the tire valve not clearing the hub..
I've tried multiple valve types and no luck with clearance.
It will be a major safety concern if the hubs rubbing the valve as it rotates!
Anyone had this issue at all? OR a solution, searching for various valves for the 11mm rim hole.
Given the rim is 12" and its a pretty big motor at 10-12kw there is really no clearance..
I've attached a few pics, one from the rim looking through the valve hole that shows the hub
One of the many valves I've tried.
And the QS drawing.
I've dropped QS a line for advise also, I think there is a tolerance issue in manufacture.
I've tried multiple valve types and no luck with clearance.
It will be a major safety concern if the hubs rubbing the valve as it rotates!
Anyone had this issue at all? OR a solution, searching for various valves for the 11mm rim hole.
Given the rim is 12" and its a pretty big motor at 10-12kw there is really no clearance..
I've attached a few pics, one from the rim looking through the valve hole that shows the hub
One of the many valves I've tried.
And the QS drawing.
I've dropped QS a line for advise also, I think there is a tolerance issue in manufacture.