Joelthewelder
10 mW
- Joined
- Aug 14, 2020
- Messages
- 21
Joelthewelder said:
Balmorhea said:Joelthewelder said:
I’d be surprised if the motor’s putting out as much as 8kW when you’re stuffing 12kW in.
Joelthewelder said:
AltLiving said:Very nice, your build looks great. How difficult was it to widen your frame? I need to do something like this myself, I have almost the same frame I believe. Have you had any of the SPIM08HP cells fail on you? Ive lost 6 in the past 3 weeks, I think my issues is with the plastic holders. I had no issues before adding the holders to the cells to better secure them to the frame. How did you go about mounting yours if you dont mind my asking?
I made these bus bar deals out of copper to squish 2 tabs on bottom side and 2 tabs on the top together. Had to make 20 of them.josephm15234 said:What did you use for connecting the cells together? I have a bunch I want to build into a 20s2p pack
AltLiving said:I am not sure what the OP used but I used a pop riveter (it was cheap and seems to hold up nicely) and it gives you something to soldier to as the tabs alone are difficult to soldier to. Hope your 20s 2p pack turns out great, I am trying to squeeze a 20s 3p pack of these cells into my frame.
AltLiving said:Very nice, your build looks great. How difficult was it to widen your frame? I need to do something like this myself, I have almost the same frame I believe. Have you had any of the SPIM08HP cells fail on you? Ive lost 6 in the past 3 weeks, I think my issues is with the plastic holders. I had no issues before adding the holders to the cells to better secure them to the frame. How did you go about mounting yours if you dont mind my asking?