Recumbent Ron
1 mW
- Joined
- Jun 27, 2018
- Messages
- 10
Did my first DIY recumbent etrike install, have 750 miles so far, love it but have some questions. I bought a 26” Voilamart 48V 750/1000W rear brushless gearless hub motor. At 1000W it does 33 mph on flat ground, at 750W option it does 17.8 mph max on flat ground, despite the sellers claimn of 24 mph at 750W. Do I need to reset something on my SW900 perhaps?
Also, the Pedal Assist is always full power, 1000W, trike takes off full force. Contacting seller, they tell me that is the only option, despite this in the ad for the kit:
* Adjustable 5 level intelligent pedal assist with twist throttle
* LCD display shows battery level and pedal assistance settings
* Crank speed sensor for 8 Point High Efficient Pedal Assist
Is there something on the SW900 I can do to adjust that as well or is this controlled by the controller?
Additional information, if it helps. My battery is a 48V 1000W 15 Ah Lithium Ion. Here is the information printed on the controller:
DC MOTO CONTROLLER BY LITHIUM BATTERY
Voltage: DC 36-48V Off Road: 26+ 1A (1000W)
In Rcad (with speed limitor): 22+ 1A (750W)
SPEET SETI:1.1-4.2VDUAL MODE Booster:1:1
Thanks much for any help or suggestions!
Also, the Pedal Assist is always full power, 1000W, trike takes off full force. Contacting seller, they tell me that is the only option, despite this in the ad for the kit:
* Adjustable 5 level intelligent pedal assist with twist throttle
* LCD display shows battery level and pedal assistance settings
* Crank speed sensor for 8 Point High Efficient Pedal Assist
Is there something on the SW900 I can do to adjust that as well or is this controlled by the controller?
Additional information, if it helps. My battery is a 48V 1000W 15 Ah Lithium Ion. Here is the information printed on the controller:
DC MOTO CONTROLLER BY LITHIUM BATTERY
Voltage: DC 36-48V Off Road: 26+ 1A (1000W)
In Rcad (with speed limitor): 22+ 1A (750W)
SPEET SETI:1.1-4.2VDUAL MODE Booster:1:1
Thanks much for any help or suggestions!