FS: Prototype Ashwoods IPM Motor / Transmission assembly, ~3:1 gear reduction, F/ RWD EV conversion

okashira

10 kW
Joined
Nov 17, 2014
Messages
963
Location
Houston, TX
I have a prototype assembly that was designed by a company that is now defunct.
The assembly was tested but never used.

It's an Ashwoods IPM 200-66 paired with a custom designed gear reduction that terminates in a female spline for attaching a standard drive shaft.
It's intended to be used in the front of RWD conversion. With the reduction ratio built in, the final reduction can be 8:1 to 14:1 depending on your rear end ratio.

It has an encoder / resolver and can work with Curtis SE type controllers or any controller that will run an IPM motor really.
Curtis has specific tunes that they developed by dynoing this motor in the UK.

3D cad can probably be provided to the buyer.

Motor is made in the UK, transmission is made in the USA and the UK.

I have no idea what this will go for, and I'll probably list it on Ebay

Motor is rated at 21kW peak mechanical (not electrical) power but that's only at 48v.
I suspect 50kW or more is possible with higher voltages.

you can find specs for the motor by googling "ashwoods IPM-200-66"
 
Interested in the motor for a motorcycle.
Any pictures of the drive ?
Where will this ship from ?
 
Back
Top