erth64net
100 W
I've got a Scorpion 4025-16, which is designed for a 6mm shaft (slight press-fit when installed).
The dilemma is; the freewheel/clutch-bearing that I'm eyeing needs to slide onto a 12mm shaft, so...I'm seeking a 125mm long shaft, where the first 90mm is 6mm in diameter and the final 35mm of length is 12mm in diameter.
I have a small 4x5 metal lathe, but have never tried turning shafts, especially ones needing a "slight" press-fit; does anyone have any idea what the success rate is for such an attempt (I've got, maybe, 50 hours experience using a lathe), and/or if there's a machinist/shop/store out there who has more skills and better equipment for such a task?
The dilemma is; the freewheel/clutch-bearing that I'm eyeing needs to slide onto a 12mm shaft, so...I'm seeking a 125mm long shaft, where the first 90mm is 6mm in diameter and the final 35mm of length is 12mm in diameter.
I have a small 4x5 metal lathe, but have never tried turning shafts, especially ones needing a "slight" press-fit; does anyone have any idea what the success rate is for such an attempt (I've got, maybe, 50 hours experience using a lathe), and/or if there's a machinist/shop/store out there who has more skills and better equipment for such a task?