Hi Bas
I am trying to design multi inverter application. I have some questions maybe others will benifit from.
1. Can Lebowski controller be run without throttle 2 connected? Do i have to connect its input to GND?
2. How would you go by using Fault/desat output of drivers? It is a open collector output of the driver module. Can i just use one fast PNP transistor to connect Enable pin to GND (it is the Reset function)? Or would you use another chip like arduino? What happens in code after reset if Enable pin gets 5V back? Would it be better to just cutoff 5V from Enable side of resistor?
3. About CAN pins.. If i dont use them, do i also have to connect them to GND? Or for that matter every pin i dont use?
tnx
Arber
I am trying to design multi inverter application. I have some questions maybe others will benifit from.
1. Can Lebowski controller be run without throttle 2 connected? Do i have to connect its input to GND?
2. How would you go by using Fault/desat output of drivers? It is a open collector output of the driver module. Can i just use one fast PNP transistor to connect Enable pin to GND (it is the Reset function)? Or would you use another chip like arduino? What happens in code after reset if Enable pin gets 5V back? Would it be better to just cutoff 5V from Enable side of resistor?
3. About CAN pins.. If i dont use them, do i also have to connect them to GND? Or for that matter every pin i dont use?
tnx
Arber