jeff.page.rides said:
OK, I've been playing with it a little more and I think I understand it?
I turn the display on and then I go to level 2 Tour and push the light switch twice then toggle through until it says E02 and push it one more time E02 flashes and that puts it in Power Assist for all 4 levels is this correct?
Then If I go to Level 3 Sport push the light switch twice then toggle through till it says E02 and push it one more time it flashes and that puts it in E-MTB for all 4 levels is this correct?
I haven't taken it for a ride yet because I've been trying to figure out what I need to do when I'm out on the ride.
Please help and explain!
Thanks!
Yes, to set "power assist" and "e-MTB", what you wrote is correct.
Four assistance levels are available for each mode.
jeff.page.rides said:
It would be nice if the double push on the light button didn't turn the light on and off each time. If it would just stay on or stay off in less you pushed it a single time then it would turn it on or off. With the light constantly turning on and off it's hard to see the changes.
I do not understand what you mean. Can you explain yourself better?
Keep in mind that the display is not programmable and from the motor controller I can only know the number of the level and whether the light is on or off.
Sorry, I use the translator.
Regards