LightningRods
1 MW
I used to have YouTube videos showing how to put these disassembled “kits” together. I took them down about five years ago when I started shipping the drives fully assembled. People were seeing the videos and then getting the incorrect impression that I was still shipping disassembled. I checked my YouTube account for you hoping that the videos were in an inactive folder. They’re gone.
Start by mounting the upper bracket with jackshaft. There are two M8 bolts on the right, output shaft side of the motor. The left, non output side mounts with the M5 motor case bolts. This will put the upper frame hanger to the back of the upper bracket and the big bracing plate to the front, viewed from the motor output side.
One you have the upper Jackshaft bracket installed Install the lower bottom bracket using the next three M5 motor case bolts counterclockwise. Looking at photos of assembled drives should make this pretty obvious.
Start by mounting the upper bracket with jackshaft. There are two M8 bolts on the right, output shaft side of the motor. The left, non output side mounts with the M5 motor case bolts. This will put the upper frame hanger to the back of the upper bracket and the big bracing plate to the front, viewed from the motor output side.
One you have the upper Jackshaft bracket installed Install the lower bottom bracket using the next three M5 motor case bolts counterclockwise. Looking at photos of assembled drives should make this pretty obvious.