SteveDillon
1 mW
- Joined
- Oct 14, 2020
- Messages
- 10
Hi,
I'm planning to use the github 'project'
https://github.com/stancecoke/Minimal_E-Bike_Torquesensor_Precontroller
to interface between an erider torque sensor and a kt controller.
I'll have to make a few changes to the software to make it work with the erider, and I'm not totally confident on my ability here, but in UKlockdown phase2 I need a little project.
I've been communicating on github, and understand that the open firmware for the KT controller can do this without the need for the digispark, but that project looks a little beyond my knowledge at the moment. Maybe I'll attempt that later.
Bits should be arriving over the next week or so.....
I'm planning to use the github 'project'
https://github.com/stancecoke/Minimal_E-Bike_Torquesensor_Precontroller
to interface between an erider torque sensor and a kt controller.
I'll have to make a few changes to the software to make it work with the erider, and I'm not totally confident on my ability here, but in UKlockdown phase2 I need a little project.
I've been communicating on github, and understand that the open firmware for the KT controller can do this without the need for the digispark, but that project looks a little beyond my knowledge at the moment. Maybe I'll attempt that later.
Bits should be arriving over the next week or so.....