Recent content by 808

Hello, World! I am trying to identify the manufacturer of this controller to see how I might communicate with the controller for parameter configuration in a GUI that shows all parameters. Pictures attached. Text reads: (I "think" it is Bafang) PT-58.8V-CAN-A LF9CGA-220202355 This 58.8v/22A...

Hello GalStaf, I am sorry I did not reply. I moved from GenZe to another brand. I do not recall if I changed the controller. The GenZe is a robust system. The problem probably was a motor (the GenZes were in an app-based fleet, so they took MAJOR public abuse and deliberate vandalism). I hope...

Any info on pinout of this plug on the Dapu 36vdc ebike controller? Thank you.

Thank you for the links to the parts, and thank you for the tip with the crimper.

Looking for sources for standard, six position (only five populated - red, blk, yel, grn, blu) ebike motor and controller. Also pins (male & female) and crimper. My searches show only motors, controllers and ebikes... not connectors, pins, tools... Thank you. See picture.

. (to follow thread)

Looking for information on how the Dapu DPCKTQ-01 (or ZW01) drive-side, torque sesing crank and its PAS circuit card (which connects to the controller on a flat 5-pin connector, not a Higo or Julet) work. The magnet is lightly magnetic and continuous (concentric). Testing proved it is not...

Write to ebikeling support. Ask for drawings to help fix your Amazon purchase, don't give them a full story; "Hi. Having trouble with your XYZ from Amazon. Do you have drawings?" Their info email should direct you to support: info@ebikeling.com (or try "support@..." While you wait, draw your...

RED, YEL, BLU... Brakes?

I will check my controller and PAS for RED YEL BLU.

I had 10A fuses burning with 48vdc battery connections. Take a look at NTC THERMISTORS...

Trying to source this PAS crankset (pics). The drive side crank has two concentric, solid magnets. The number stamps do not help (me). Thank you.

Are the three wire colors in the black connector RED BLK WHT? And, did you trace where the wires go? Also, in two e-bikes that I know, the controller is secured to the frame either at the bottom end of the down tube (below the battery), or behind a panel with recessed screws. The controllers all...

Replying to myself for others... Sure enough. Battery low. Recharged it. Motor AOK.

My blink code is four, short, red (red red red red, pause, repeat). The motor seems good, and the EA/PAS button cycles RED/GRN at startup, then settles GRN. The button goes BLU when pressed. Then, as I pedal, the motor assists, but soon (three lengths of a foraging horse - that's for the Brits...