Recent content by Adarsh881

I've replaced all the bearings with proper german ones except for the blue gear for I could not get them out without damaging the blue gear...is there any way to get them out without using a press? Thanks for any advice 🙂

Maybe you are not logged in as administrator? That solved it for me...

I just upgraded my 36v to a 48 v motor with a 17.5 ah 48v battery 13s /5p Does someone know what to put in on max battery watts. The battery can handle 25amp continued but I don't think this motor would like that... Thanks 👍😊

Hey I just built my 'old' 36v motor on a friend's bike and would like to reset the odometer. I tried to push the + and - and on/off together for 10 seconds but the vlcd5 screen turns off after about 2 seconds and the odometer is not reset.. Am I doing something wrong or does this not function...

Thanks for your advice :bigthumb: Indeed turning off the odo correction did the job. I think the odo correction was working but it doesn't correct the trip distance. As for the rain I just drove in quite heavy rain and so far it is still going... 🤞🏼😄

... a few questions about the usage of the vlcd5 display.... Every time I start up the display it takes a few hundred meters of pedaling before the speed is displayed on the screen. Just wondering if that is normal or can I change something in the settings? I've noticed that the odo correction...

:bigthumb: thanks again!

Thanks again very helpful!👍🏼 I'm just wandering why Embrusa advises to leave the cadence in standard mode instead of advance mode... I thought the advance mode would give more accuracy? Also those 4 assist modes I'm curious what they mean. I'm just using the power assist mode as that is what...

Yes I have the exact same thing... Didn't find what it is though....did you get any wiser?

Thanks that's very helpful👍 I just checked my range it's 130 to 270 so I guess that's ok. So in the TSDZ2 Parameter Configurator should I change the torque sensor to adv. and change the range to 140 instead of 160? I also checked the "pedal torque ADC step" with 22.6kg on the pedal and the...

Yes that was all it took.. thanks!👍🏼😊

So I would like to calibrate the hardware sensor by adjusting the two screws. What should be the no load value when reading of the vlcd5 screen? I'm having the "Tsdz2 open source firmware adapted to vlcd5" installed on my motor. Wiki says about the torque calibration that the no load value...

Read this thread. A lot of people have the same issue: https://endless-sphere.com/forums/viewtopic.php?f=28&t=79788&start=7150 However if the wobble in the chainring turns out to be in the sprag clutch I wouldn't worry about it because when the sprag clutch locks under load it will center...

I'd love to have a go. Especially if it reduces the sound a bit. I still would like to use my blue nylon gear though. Any thoughts on which oils would not soften the nylon?

Hi Jim After just 150km(!!!) I have the same problem and just ordered the parts to do the same as you have. Some months have passed since you fixed it and I was just wondering if the problems are still solved. Is it btw possible to change the bearing on the torque side also? It has some...