Recent content by amps2volts

What username on here? Great Es Can't find. I have a buddy that has a nice 3D printer I could make a bunch for people that want them. Oil cooled motor sounds even better, post results sure lot people would be interested. When push 3kw cyclone 50+ volts @ 40+ amps contentiously under a...

That fan mod effective at cooling the whole motor well? Did you have the STL/3D printer file for it? I love to try mod on my bike. I have a 3Kw Cyclone 52v lion pack on a 120amp kelly controller limited to 60amps. It consistently getting near 60c on motor casing. I haven't put a temp prob...

I decided to go with IGH got good deal on a rohloff with external mech $1,000 with shipping. Think at even 3Kw could handle it. Will find out and report results. Just need program motor to ramp up speed slow. That will keep torque within 135nm/100ft lb. And keep speeds around 45km/h or...

I have been wondering what best grease to use is too. I repair a lot of laser printers. Many hot running nylon / plastic gears in them. What I found works best is Super Lube multi purpose grease. I may try on geared e-bike motor. Here info on it Super Lube® Grease is a patented synthetic...

Thought this would make a good discussion/debate on here. I'm building my first e-bike and can't decide what route want to take for drivetrain. Here are specs of my bike so far. -Frame: 2009 Trek Fuel EX8 full suspension -Motor: Mid Drive Cyclone 3Kw from Applied Future Technologies (AFT)...