Error: cannot communicate with the device.
Just tried new Stlink and flashing ver 19 is still same: Successful in the stprogrammer (both lcd and motor) but once switched on, no controls from the up/down arrows, only power button works.
Now tried the ver 20 and this sems to have worked - now I...
I have found my ktlcd3 on ebay. Never used but old.
Flashed fine.
Now I ve tried to flash v.20 and my Stlink seems dead... No lights, windows "discover" sound can be heard but stprogrammer does not connect with the motor or lcd. 5V output is present but on 3.3V line, only 2.02V.
Seems as I have...
My lcd3 has STM8S105 chip in it. Flashed with v.19 just fine...
Opened it up again to check for shorts, none visible. Will try to update it with v.20 later on.
As I didnt wanted to splice the display cables, I have soldered them directly to the board. But cant see any fault in there either...
Ive received my order from Pswpower and immediately checked the version.
There is 5v between gnd and swim pins so its a v1...luckily.
I have also wired and flashed ktlcd3 display using file KT-LCD3-v0.19.0.hex.
Then I went on with flashing the motor with TSDZ2-v.0.19.0.hex.
I have read and...
Ok. Ive taken the plunge and just ordered a 48V 750W kit from pswpower. Will report the controller revision once delivered (if I figure out how to check that)...
Thanks
I have just stopped myself last second from ordering a tsdz2 kit from pswpower. Asked them if the new kit is a v2 version but they've only replied as "flashing the motor will invelidate my warranty". They dont want to tell if its an old version or open source resistant one. So I will hold for...
For sale my high powered electric bike, bomber clone in good condition, complete with charger and two alarm fobs.
Owned the bike for over a year, never caused me trouble. Has some surface rust in places - nothing major.
Powered by currently most powerful hub motor available - QS273 (winding...
Hi. Ive built a bomber style ebike I cannot ride anymore due to wrist problems...
Used a black EEB frame, qs273 motor, sabvoton 72150 and built the battery using lg mg1 cells. Battery in config 20s23p gives 84V and over 60Ah of capacity. Almost no sag at 150A draw. And reaches 60mph in about...