I switched to the Phaserunner Suite BBSHD settings for 52V battery and it works great (I don't really need to change gears as I did prior).
However, I have a problem with power cutting out. All of a sudden I just lose all power (CA and the bike is powered on, but no power to motor). CA can...
https://endless-sphere.com/forums/viewtopic.php?t=91069
It still seems to jutter a bit, but not as bad. I will post an update if I find anything out. Currently installing heatsinks.
Update: Juttering gone after reading in another thread to turn the phaserunner to be in pure hall sensor mode. I also moved the minimum throttle voltage to where it starts humming as suggested before and the on/off seems to be much smoother.
Unfortunately it still seems to lose power (on pedal...
I tried these settings with bbshd at 2500watts limit with a 50amp continuous battery, but still get juttering :( Any insight on what causes the juttering? It eventually pops the chain off if I let it go for too long.
How do I wire in my current gearsensor?
I am guessing just have the two ebrake sensors and gear sensor wire into the same connection and connect that to the ebrake connector on the CA3?
I am about to pull the trigger on purchasing a CA and phaserunner and I will figure it out as I go.
I assume I need the CA3-DPS rather than the CA3-DP? or can I use the speedo from the BBSHD unit somehow