Recent content by banzai

Don't know if you are looking for this info... I made a search with mobilgrease 28 Specs and these are greases equivalent: Specs: MIL-PRF-81322 -- CDSEA395/B NATO -- G-395 Shell Aviation grease AeroShell Grease 22. Royal Lubricants grease Royco 22CF (also 28CF). Castrol grease Braycote 622...

For the combined action lever you could probably adapt the sensor for idraulic brakes. https://electricbike.com/forum/forum/knowledge-base/motors-and-kits/bbshd/22053-how-to-install-your-bafang-hydraulic-disc-brake-sensors About gears, for a fairly hilly road you should use a 32 front gear, and...

Consider that you don't need to dig in the grey silicon, you can also put the small circuit in any place before the throttle and have two wires going back to the pas connector inside the controller. It's a less "elegant" solution but it's exactly the same.

About throttle sensitivity, did you read this solution? https://endless-sphere.com/forums/viewtopic.php?f=28&t=93977

Just got my Satiator, had a few issues with finding the right cable to update the firmware, as I do not have a CA and its cable. Tried with different TTL USB interfaces, the one with wch340 chip did not work, same with other two with prolific 2303, at the end I found the xiaoxiang BMS PC...

To find the brown cable, remove the gray pot in the area near cable access, carefully with a small blade screwdriver.

Get a specialist rework your battery, it's probably a 13S4P, can be rearranged to 10S5P.

If you have the standard pot, clean it all with a small flat screwdriver, specially around the edges, till you can't see any pot. As you see, the pot is not really very sticky, once the edges are free, use the two screws that fix the heating transfer to apply force alternatively left and right...

Thanks. Just got a second new controller, 36v500w, marked october 2018, think that best way is remove pot from the area where cables are welded to board, the zone where cables enter the controller is a mess and I fear that if I remove the pot there it will be impossible to have it waterproof...

Traced the spot, goes to Brown cable, P+ from display cable. Anyone can give a clue on ferrite beads values? Managed to found four of them near mouse/keyboard ps2 connectors from an old mainboard, could be ok? Stupid question maybe...

About the transistor to be used, I have a MPSA06 and a MPSA14, can any of them replace the others listed in previous post?

Thanks Justas and fechter, now board at home and I'm out, yes agree with you, I found the main cable just near connector compressed, need to verify if some of the cables are shorted. I tested the Fets from the three cables (YGB) and they seem disconnected, but if I test to the fet legs, and have...

Searched full thread but could not find a good pic of the back side of a bbs02b controller. I have a 36V500W with some burned parts, resistor suppose, if someone can check with a miltimeter to give me the data of the burned two and maybe the two nearby... The place where resistor are attached to...