Recent content by Bg-electric-cycle

I did eventual get the minimum fee resolved once was the situation was explained. Freewheel was eventual fitted and all good. After more thousands of kilometres than I recall or logged it’s time for new Tyres. The stock Tyres served well not one puncture and I pulled some big chunky pieces of...

Dependant upon your throttle? They are effectively just one electronic component a hall sensor. Always been that way or something recent? Could be a number of possible solutions?

All functions are retained exception of switching power the new cable is six core rather than five. The different voltages 5v throttle, 60-88 volts display of was also present on the key switch, 5v or 12v key switch for reverse. Don’t forget the fuses! I never did utilised the voltage...

I did place the arrow in the wrong area. I found the original photos and wiring plan.

Yeah sure Tommycat, you have permission. Just remember a credit now and again does help, I have somewhere photos of the original throttle after I rewired the thing. Dam useful to access reverse & keep the voltage display functional. After this experience I’ve lost all competence in these...

After some study I just hot glue the hall sensor here were the arrow does point?

Previous throttle was exact same and I rewired to allow the switch to access reverse feature on my Kelly controller. However, when I took the cover off this time the throttle was on the handlebar and the hall sensor came away and I have no idea how to fix this? Anyone with any pointers? I’ve...

Just went to order a spare part and been told minimum order €250! The freewheel actual fact broke from the first week or two although took me a while actual figure out the intermittent noise. When I could no longer peddle I knew where the noise came from.

Anyone took this beyond the pixels on a screen?

Post a picture of your charger, many have a small blue pot inside and are able to dial down the voltage and charge current.

Anyone with a manual for this unit? I appreciate it’s a generic SW display system. I’ve got varying versions of the manual but not the specific one as issued by Fischer. Any pointers much appreciation.

Vector Typhoon, at EV charge station. Successful initialisation of charge station with RFID, card. I’ve charged the pack several times with the Kelly controller live and experienced no problems. Also charged with the alarm activated and found no problems. The higher voltage up from 52v...

Now having extended the frame width was able to build King Kong battery a 21s 18p 60+Ah pack. Been ramping up the voltage just rode at 86volt with the Kelly controller dialled down on battery and motor phase current less than 50%. Level three power switch is at 80%. Battery has available a...

Yeah, I’ve extend my Typhoon, 10mm each side and changed out the bottom bracket 177mm. Did involve grinding the left crank down. Beyond 177mm is more complex as the chain alignment must be taken into consideration. I have a plan resolve the issue but as yet not ordered any parts to validate...

Thanks to the original if only the cluttter wasn’t here. This post gave most interest being in Eu, we have Type 2 connector and I’m finding my adapter plug won’t function on the big ABB units see EL Drive App. In fact over past few days I’ve found three Type 2 sockets and either switched off...