Recent content by Carl.H

  1. C

    Removal of speed limit on Dapu controller

    Yes Hold "set" for 6 sec when you see wheel size settings klick "set" one more time, then push "up arrow"
  2. C

    Yuyang king 40amp controller

    Did u disconnect the blue wiers 2 of them, speed limiting? The pairing password is 12345678
  3. C

    Speed limiting

    Hello I have a hub motor 800w 60v, Connected to a controller 1000w 60v max 28A. and max speed is 32 km/h 18 inch wheel And I need to make it go max 25 km/h, there is some way to put a resistor on the throttle, but how to? my english is bad sorry :(
  4. C

    new motor? (1000w 60v)

    Hello again ford442 The motor are integrated in the rim on the citycoco. That's why the front is steel and the rear is aluminum So there's probably best to change the whole thing. Do u have pictures of the controller?
  5. C

    Adding a 3-speed swich

    Ok are those sine wave controllers? I found similar controllers to the one I posted in the first post. And they have the 3-speed connectors. So I guess there have to be some soldering points were they are connected. Google ain't that helpful or I am searching in the wrong direction
  6. C

    Citycoco/Scrooser throttle

    Ok how is it going ?
  7. C

    Citycoco/Scrooser throttle

    is it quiet when it off ground and spinning?
  8. C

    Citycoco/Scrooser throttle

    ok are the old and new controller exactly the same type?
  9. C

    Citycoco/Scrooser throttle

    Hey did u connect the old controller?
  10. C

    Adding a 3-speed swich

    Hello yes i see, then i will change this one for the 50 amp yuyang king controller, its a bit sad to do it because i will miss the silence, all u hear is a high pich on going beep The yuyang king is supposed to be more powerful, maby it is but not that much, it has how ever ways to controll...
  11. C

    Citycoco/Scrooser throttle

    Hello I know it's a silly question but have u checked the hall connectors and phases? And if the cable connected to the engine looks good
  12. C

    Adding a 3-speed swich

    Is it possible to add a bluetooth module to this controller? I have one from an YuYang king controller, I think it has 4 connectors. And use your app to monitor current and speed, That would be great
  13. C

    Adding a 3-speed swich

    Ok so there is a way to kontroll rpm of the engine then mabye?
  14. C

    Adding a 3-speed swich

    So there is perhaps some way to make it run slower? I want it to do max 20km/h
  15. C

    Adding a 3-speed swich

    The controller is from a citycoco (scrooser) 12 mosfets and sinewave drive only 1000w U can almost get them for free http://www.chinaglobalmall.com/products/547408992949
See more
Back
Top