so I tested the motor with the charger.
display starts up voltage 57v
bike runs for a short time then the voltage cycles down to 30, the speed goes to --.- and there is an FF error.
looks like the controller?
G
ok i have a variable voltage DC power supply that I could use-
I guess I set it at 50ish volts straight to the motor cables red and black?
Then switch on the display and see if the voltage holds?
Thanks for your help
ah a misunderstanding.
I had plenty of battery left when it cut out.
0v was the reading on the display immediately after the cut out.
Now when I switch on the battery shows 56v (when it does switch on, which is not every time)
Then the volts start cycling down till about 30v then the display...
Good morning,
I have a feeling I may have blown my controller on my new BBS02.
I was ridding up a hill fast and the engin just stopped.
The eggrider display went to 0v for the battery then sort of came back up slowly to 30v (I have a 48v battery)
I unplugged the battery and recharged and left...