Recent content by chri27.5

Hi, battery voltage cut off, must be set at 39 V for 48 Volt battery.

Hello, today I tried the Mbrusa modification to fix the overrang on lcd3. I must say that it works very well, I posted a video made with the phone, obviously it is not the best, but the arrest is clearly visible. https://youtu.be/r3RW_21sJTc Ciao, oggi ho provato la modifica Mbrusa per...

Hello, today I tried the Mbrusa modification to fix the overrang on lcd3. I must say that it works very well, I posted a video made with the phone, obviously it is not the best, but the arrest is clearly visible. https://youtu.be/r3RW_21sJTc Ciao, oggi ho provato la modifica Mbrusa per...

Ciao a tutti, Sto testando le ultime modifiche con Mbrusa, ci siamo quasi, bisogna aspettare ulteriori test per rendere definitive le modifiche. Non ha senso rilasciare versioni che potrebbero causare problemi nell'utilizzo, spero che voi capite e pazientate ancora un pochino, vi posso...

Hi Elinx, we have been testing this new version since December, I can tell you that the work done by mBrusa is exceptional, for my part I can say that I struggle to choose which mode to use between: Pawer assist Torque assist eMtb mode because both are fine. I can't wait to try this version and...

Hi Stancecoke, I agree with you that fewer parameters are put into the Gui, the simpler it is to use for less experienced users, but to do a good job all the parameters present in config.h should be put, exactly as mBrusa did. Thanks in advance for your contribution.

Hi Nfer, with vlcd6 the light button and the down button. Attention to work well you have to hold for about two seconds. if you need help I can make a video.

Ciao thineight, ecco il link https://endless-sphere.com/forums/viewtopic.php?f=30&t=104232

Hello, for assembly, position the motor / bike horizontally, then put a little grease on the springs and position them in the special oval slots, then place the new ring in position. At this point you can choose two ways to mount the other part of the sensor: In the first way it takes two...

Hi Elinx, I just made the calibration of the hardware sensor, thanks to Mbrusa I was able to read the ADC values, when empty it read 49.2 and 62.1 with the maximum force applied on the crank in a horizontal position, this calibration I did because having a reading field very narrow the engine...

Good evening stance coke, today marcoq has officially published on jobike that it will no longer release any version, its work ends like this. The cause of this decision was the publication of the decompiled sources of its configurator without consulting it, and without its permission. Now we...

Hi Elinx, Mbrusa with the latest modification released used the same conversion of casainho, just to compare them in the same way.

Hi casainho, the values ​​shown in the photo on the vlcd5 display measure empty with horizontal pedals 51.8 standing with the maximum force measured 99.3 this engine has an incredible power that I never understood why, I have two other engines but their power and almost 40% less, today I can say...