Recent content by Compoundbike

That Motor and the Controller is tempting but hard to get it work on a Bike. :D

Hello Guys, has someone managed to get PAS working with 75100?

Better late then never.

I will make a picture at the Weekend. One is CA-V3. 1 the other I must check out.

Cycling Analyst: One is configured for Sabvoton, one is for Bafang. I was thinking each about 100€ and shipping. Also Reention Case Ebike Battery 13S5P or 13S6P Sanyo/Samsung with Bluetooth Smart BMS for sale almost Brand new. 350€ / 390€ Also 72 x Molicell P42 also almost brand new, but...

So I have bought such a used cheap scooter, but can't get it to work. What I have replaced : Controller + Display What works: Motor works with a different controller(Tested only in "Walk" mode) . Cables measured no connection issue. Battery also works. Any other issues on these models...

Thanks for the Reply, will consider them.

I am a bit confused since I have replaced the main shaft and the POM gearing. However there's a gap of 2 mm the bearing can't go deeper to the housing. Then I have noticed I have the older version, anyone knows where to order the older (narrow) version of the shaft and gear.? Couldn't find...

Hi are the LG INR21700-M50LT available again?

"Made in Italy" I hope it doesn't have the older FIAT build quality. :lol:

My mistake I meaned discharge Rate. 12.5 Ah: 5.6= 2.. "These batteries are from a canceled car project" I guess those cells won't be easily released again.

Im grinding the "mosquite bites" with a dremel until they're flat with the end cap and then Weld it. So far I have used plenty of these the capacity and the performance is fine.

C-Rate looks like 2 times? it's also a expensive cell. Probably good for long range if done right.

Has Anyone used those cells? Just saw those on NKON they're claiming to have 5570mAh at least with 12.5 ah continuous.

Looks good, a Coaxial motor can reach easily 50mph, hope it has enough Carbon to hold the Bike together.