Recent content by craft211

So im having an issue with my NEW Turnigy Aerodrive SK3 - 6364-245kv. im getting a noise out of the motor when running at low to mid RPM. as well as its not a smooth run like the other. its kinda jumpy at low RPM. it also "looks" like it is running slower than my other one.(same motor) normally...

I dont have that tx, but i want to say channel 1 and 2. I dont know if it matters, never really tried plugging them in out of numerical order. Unless someone on here has on and can tell you quickly. I'd consult the owners manual to find out the recommended setup.

most tx have multiple inputs. i have the Wiiceiver that has 2 inputs and another popular on on here is the HobbyKing HK-GT2B that has 3. do you have a remote yet?

i actually have this same question. currently i am running everything in 2 separate sections that only meet at the Wiiceiver.(check picture below, Red Line is the separate sections. ignore the tape, its temporary) each motor connects to its own ESC, bec and battery. the batteries are in series...

Now that i have my board built. I'm in the process of designing my enclosure. I'm actually designing it around the board itself. rather than use a cover plate or universal pre made metal/plastic box. Im going to build the box out of either High Impact Styrene Sheet or a uv treated ABS Sheet...

hey guys, just ran accross this on BAJABOARD.com.au facebook. looks like a nice controler but basic. from what i can tell only throttle and brake.

I'm using 12s ESC from diyelectricskateboard.com. what do you what mean voltage?

I'm wiring up my first E-board and have run into a little bit of a... pause. I want to make sure i figured this right before I hook everything up. Please let me know if this diagram is accurate. disconnect the positive line from the ESC to the receiver and in place of that connect the positive...

Thank you furp. that was better info then i was expecting to get. i will keep that info in mind when i start building it.

Just curious if anyone has made there own deck? I'm looking for a good woodworking project I've never done and from what I've read and the videos I've seen it looks fun! Also if anyone has made there own, any suggestions on what materials are better then others? Anything that you did you would...

I know this is still theory at the moment, hope no one minds me adding my 2 cents. I dont have alot of experiance with electric boards but i do with electronics and some RC everything else. Also, I haven't seen anyone mention braking. dont know if everyone uses it, but i've seen it mentioned a...

Will these photos suffice? [EDIT] Sorry. messed up the url for the photos. hope that helps!