Recent content by cruzin

good luck on your build. i have found that the more detailed and safety orientated you are, the more enjoyment you will get out of your completed project. nice bike!

I totally get and agree with this. Perfect perspective.

he lived in fort pierce, a few miles from me. not a huge city, mostly farms and orange groves with a small town on the river and ocean side. the inner part of the city is quite diverse with mostly black and hispanic families. lots of drugs, crime and even murder on a regular basis, with a...

I think Im just gonna use another hub that I have. I just hope the quick connect is the same wiring. Should be, there is 3 big pins and 5 small pins. Hopefully the colors are all the same.

I have it apart. It does not appear to have any kind of adjustment. The axle has a lot of wobble, and the coils move with the axle. I am just worried about riding it like that. I dont want to do any damage.

I have a Prodeco Phantom x2. The rear hub is loose in the axle. I do not see any way to tighten it, other than taking the hub apart. Has anyone had experience with this? I dont want to tear it apart only to find out theres no way to tighten it down. Thank you

That is with the controller hooked up. Its the same coming straight from the controller. I test the pin the middle on each one and they show 0.00 I opened the controller, didnt see any capacitors swelling or any burnt spots.

I got the other side open, and partially pulled off. The freewheel comes off with the plate almost 4 inches. I was able to visually inspect the sensors. I didnt see any visible damage. All three sensors seemed to be in one piece. Im getting 4.9v from the blue AND yellow at the little board on...

the green and yellow are both changing from 0.03 to 2.5-3.5 when I spin the wheel. The blue stays at 4.97 My meter is working correctly. When the bike fell, almost all of the wires were skinned and touching. I would really hate to consider this a bad motor, as I havent had it for very long. I...

re these the sensors that I need? If so, I will order a few of them. http://www.mouser.com/Search/ProductDetail.aspx?R=SS411Avirtualkey67810000virtualkey785-SS411A I will have to see if my local bike shop will mess with it. Last time they told me they wouldnt touch an electric hub, but to...

I ran a jumper wire from the point to where the wires go under to the other side, all the way to the harness. Still reads 4.97 and doesnt change at all when I spin the wheel. Im guessing that the hall sensor is bad. I also assume that it is not safe to ride it like this? If so, then I will...

After careful inspection, I did not see any problems in the wiring. I uploaded a video to youtube: PXsi8qe3KvM I dont have any wire, or I would just run all new strands. Im leaning towards it being on the other side of the motor, which I cannot access. I tried banging that freewhell off...

It is a direct drive motor. I should have added that in, Im sorry. I now have it apart again. The wires go underneath to the other side, and I can see under there to asses any damage. I will carefully inspect the wires after I remove the protective coating. Thanks

I put it back together, hooked up everything and probed the harness as stated above. Red: 4.27 volts, unchanged when turning wheel slowly Yellow: 0.03 and 3.84 when wheel turned slowly Green: 0.03 and 2.50 when wheel is turned slowly Blue: 4.97 and only goes up to 4.98 when wheel is turned...

I will do that today. Its taken apart, and I was going to try to take the freewheel off. Looks like its going to be a pain. Ill put it back together and test the hall wires.