Recent content by Dayanul Alam

In the image attached, regarding the exposed unmasked gold pads to the pins from the bus bars and phase pads circled by blue, is it necessary? Or it it alright if I get rid of it and and just keep the through hole and high current pads? It's that I'm trying to make the pcb larger so that...

I'm actually thinking of implementing arduinos, fans and temperature sensors to develop a cooling system on a seperate board. Hopefully this is more efficient. Looking forward for advice and suggestions. I will have it monitor the batteries, controller, etc. I'll release the details in another...

Are there any fan headers on the MP2? IIf not, could I just add + and - traces to the MP2 connecting from the buck converters to a header? Moreover, does the board have capabilities to connect to a Bluetooth module, just like with other open source ESCs?

Is the esc build only for qsmotor or can I use it on a Lightning Rods mid drive?

Is it the torque that matters or speed?

Max rpm is like 6200

Well yeah but I'll just get the bare motor cuz the kit is expensive asf

10kw is the peak power for the motor. It's usually 6kw.

Also the clearance between the brake disc and frame is small how is that possible? My bicycle is 2017 norco optic a7.2

What if I used those hardened steel cassettes for ebikes?

Thread 'Ways to use a cassette with a 10kw mid drive?' Ways to use a cassette with a 10kw mid drive? here's the link

The title says it all... I'm planning to mount a big block lightning rods motor on my bicycle but I want to keep the cassette.

Does anybody know how I can use a cassette with a 10kw motor?

I mean like this. We are basically viewing the pcb horizontally. That long line is the vbat terminal.

Honestly using all that solder might be a bit messy if some people dont have a fancy pcb oven. What if I added multiple holes on the battery terminals and interconnected them with the bus bars? I mean yes not much contact compared to soldering a large copper rectangle onto the board. I'm...