Recent content by demonscythe

Yes there is a connector for the display. What pictures are you needing? I can open it and photo any part you would need. Edit: nevermind I found a picture to show that shorting red and blue wires turns it on and confirmed by turning mine on.

This is probably a dumb question but for the KT controller do you have to use one of the LCD screens for it to work? I just got one and working on getting the phase wires connected but I'm not sure if I need one of the LCDs for it to turn on. I have the Bluetooth module but it has no power which...

I was able to finally get the controller powered on and measure some voltage. The AR pin measures as the battery voltage. There is another pin SL that measures as 5v and is with a ground pin that is used to cut the power to the motor when the brakes are applied. There is a pin beside it labeled...

The pad with the squiggles is labeled as LED on the opposite side of the the board so I don't think that would be it. If I'm testing voltage on the pins what should I expect to see? 3 or 5 volts maybe?

Hello everyone. I'm new to ebikes in general and the forum so if this is the wrong place please point me in the right direction. https://imgur.com/a/IBez2DK I am curious what these wire points would be used for and if this controller has the ability to have regen braking enabled. I could not...