Recent content by Drupa

Its not for the Hall issue its for the attempt to operate the reverse on my EM-50s on the test bench (The process isnt clear at all) Also tried to rcover from the throttle Hall fault by checking wires, voltage & Settings. All seems OK but cant clear the error While Throttle is connected...

Does anyone know how to get the excel file of the Port Configuration Setting? I cant reach that link from any download soure Thanks

http://www.siaecosys.com/upfile/201908/2019081354118841.pdf

Thanks amberwolf for all your detailed answers. I think I should clarify a bit since I might was misleading a bit. The original motor is 1000w inrunner with smaller diameter compared to the new 2000w motor, however I think I might gave the wrong impression about it performance. The 1000w does...

Hi All New update: I came across a document today from QS Motors which explain how to test their motors hall sensor & found out it wasnt the same way I measured! I was connecting multimeter negative probe to black wire in hall connector & posstive probe to each one of the 3 halls (YGB), The...

Thanks for the educate information Throttle = Hall :confused:

Thanks for the Tip I disconnected the motor hall plug & measured the voltage on the controller side, results are as follows: Black & red = 5.4v Black to each one of the 3 sensors input (Yellow, Green, Blue) = 3.3v Reminder: I made the voltage measurements on my no issues motor & got also 3.29v...

Correction - the value is Flux Weakening Compensation and its in percentage

The 5 pole is from old picture I took. As i mentioned I rolled back to my Original black motor until I will get the hole sensors I ordered. Update from toady: I try to run the new 2000w motor on a bench test with my EM-50s (the OEM controller of my Quad) & suprsinglly I get constant Hall sensor...

The speedo is OEM on the Quad using One-Lin output and woking fine, only when the RPM goes up bohe the RPM in the Display Tab and the Speed in my gage go crazy so it mean the Hall output really is loosing it

I didn’t change anything, the picture of the motor inside is the new motor with it original wiring & Hall sensors PCB. I mentioned before that I ordered new PCB sensors assembly of sensors type that is being used at QS motors which designed especially to work with Votol controllers, it is some...

It Means that OEM setup of the Quad I bought was the black motor & EM-50s controller. I then Upgraded the controller to EM-150 with the same original motor I played with the setting to reach best performance & wasnt happy so decided to upgrade the motor. I have then connected the new motor to...