Thank you Tumich
I got 150 Sanyo GA cells in the mail today. Great packaging, lots of bubble wrap, took a little over 2 months for shipping from Poland to Hawaii. Did a quick check on a handful of cells from each box, all were 3.65 v. I am very pleased.
mchlpeel
I saw your post and response from teklektic on the Cycle Analyst V3 thread with the temperature and resistance table for the 10K thermistor. I just measured the temp sensor on my leaf motor with my DMM. At 29.2 C I got a measurement of 8.34 resistance, which is right where it should...
Cowardlyduck
I measured the flange diameter ( center of hole to center of hole) as 9 3/16". I converted this to mm for the spoke calculators as 234 mm.
Flange width ( center to center) was 35.5 mm
I did a zero cross lacing pattern by drilling new set of holes 20 mm from existing hole, got a...
SprocketLocket asked
OK sure.
I wrote:
Hi Leafbike team
I want to buy 1 Newest 48V 1500W rear spoke hub motor - electric bike motor
Item ID #LBM481500RN
What is the winding and rpm for this motor
16*4 winding rpm = ?
13*5 winding rpm = ?
Leafbike wrote:
This #LBM81500RN is 16*4 Turn...
Thank You Neptronix for the info regarding this motor, I have learned a lot from your post and videos. Your test of the motor gives me the confidence that this motor will work well for my less demanding needs. :D
mrDS
I got some info from Leaf Bike about this motor. Standard winding is 16*4 Turn( about 630 rpm) ,They said the 13*5 Turn winding is about 520 rpm . So looks to me like 13 strands it is.
I just ordered one with the temp sensor, 13*5 Turn winding.