Recent content by eTrek

The speed sensor is used for the acceleration and deceleration ramps - which wont have much effect on the assistance curves - I certainly dont notice it missing. Makes sense now why OSF needs it - I never realised stock didn't. Yes, the cadence limit on the stock firmware is rubbish - the...

I dont think the speed sensor is needed by the motor - odd why it cuts completely when not working/present though (maybe a legal thing - Tong Sheng do try to keep the motors legal) I've used mine on OSF, with speed sensor disconnected, and error overridden, with no problems.

Deceleration is set in the Java configator.

Yes, if the sensor is not detected, you will get an E08 error and assist will be removed. Note E08 means something different without OSF. You can tell OSF to ignore error and continue with assist by: At level 4-TURBO, pressing the lights button 2 + 2 + 2 times until E04 flashes. This will...

There has to be another explanation, definitely set to miles on display and in config. Something I have noticed, which may help explain is...When set to miles on display, if I look in the hidden display menu, the speed limit is shown as 25mph, but it is actually limited to 15mph (which is...

Thanks Elinx, Both my display and the config are set as miles, I though that was OK now and the KM only thing was an earlier release? (I have wheel diameter set to max on display). Is it only the SOC% that's affected by using miles? I've not noticed any other problems using miles..? Thanks...

OK, so I just fully charged the battery overnight to 54.2 - the highest it has been in a while. The Wh consumed has reset itself :thumb: But... the SOC% was showing 62.4 when battery full - it was 28.8 before the charge. Also, it is now stuck on 62.4 - and has been for the last 10 miles...

I struggled to work out how to change parameters from the VLCD5 display. In other words to Elinx reply. Start here if you didn't enable "set parameters on startup" in the Java config... 1. Turn on display and wait 5 seconds. 2. Down arrow to assist level 0 (off) 3. Lights once, e02 shows...

Hello All :thumb: Massive thanks to mbrusa and all the developers and testers who have created this ingenious firmware :bigthumb: I've managed to get pretty much everything working as I want on my 48v VLCD5 with v20.1C.2. The field weakening is exceptional - the limited cadence was my...