Recent content by eugen

https://www.electricbike.com/zlatkos-cbm-2/ its clear dont wait order your dream bike today :mrgreen:

i solder signal vires on shunt and that solve problem- and my CBM monster have again correct CA thank you dogman however thumbs down for CA manufacturer- they newer answer on my email

CBM TEAM

i have big shunt not in epoxy but is in batery box so need time to open. thx for advice ill check asap

I have CA version 2 it was ok until 3 week ago i use reg break on long hill. On the end of hill CA was show 0 ,6 A consumption. i change all electrolitic capacitors in controler. still the same . I cut + and - from batery- after shunt so nothing remain connectedexcept CA and still showing...

this is not ok

i just order one of this what you found will see in one month what ill receive :D

""there are at least 3 different versions of display, C950, C961, C963, and each is only compatible with a particaular version of firmware that has been installed in the motor controller. If you read the display user manuals you will see that Bafang state what version controller""" also i want...

""there are at least 3 different versions of display, C950, C961, C963, and each is only compatible with a particaular version of firmware that has been installed in the motor controller. If you read the display user manuals you will see that Bafang state what version controller""" also i want...

after read all posts dont found nothing after (about promises) on this post..Or i miss something: any progress?: :?:

it is any progress on this? :?:

http://youtu.be/LAGHn3g_0YE

http://youtu.be/vu5KfznHxI8

congratulations mister i can see you are great engineer ill come asap visiting you possible we can doo some busnies :-)

it is all just to made comunication betwen chinese software and controller