Recent content by feyris

I don't find the TSDZ2 noisy. I'm still using the blue gear, with 52v battery, 12A max I opened the motor yesterday after 10000km for a check up, all was fine and the blue gear was as new.

2: You can order any power. I added a 250W sticker on mine just in case. 4: No need to add a hand break sensor for you. You may adapt the sensor to any moving part on the coaster brake, not sure how it's work. 5: no pb. 6: verify you can reroute the black cable to upper the pedals axe, it may...

Great thanks! I wanted to do the same but, wasn't able to reverse engineering the protocol! Works good on my android 10 device :thumb:

I'm use my battery the same way you do. I don't like keeping it charged so I often charge it to 60 or 70% unless I realy need a full charge My bms is bluetooth so I prefer to use the app to have an accurate soc reading.

I'm pretty sure that a 6v relay on the light signal will be ok.

I saw on gitHub that the light issue is on the pull requests. Anyway, removed my lights from the tsdz2. They now use a separate DC-DC converter on the main battery and are always on. I can use much more power than before :)

Great thanks! I missed the 'AND' part :thumb: Using NrfToolbox 2.8.4 from the playstore, I didn't need any other file than the .hex

How? I was looking for this too. I didn't find how to change variables shown in the second screen. Short up/down arrow press do nothing, and long press turn on light/walk :? Thanks.

With 0.6.5, I had the exact same issue with jiggle on start, then some kind of misconfig/ unsynchronised motor when the jiggle take some time. I never reproduced it since i upgraded to 0.6.7

I can confirm all those issues. I also have a problem with the lighting: If I turn on the light after power on but before riding, the motor wont engage. If I turn on the light during the ride, the motor continue to run, until I stop pedaling, then the motor can't restart. I'm not sure it's...

Hi. I installed the latest version on my commuting bike, comming from the stock version (VLCD5) Some questions and returns: Sometime, the interface freeze while browsing the menus. The bike is still usable anyway. As already mentioned, there is the issue saving the settings. I modified the...

I also had this issue After 20mn of ride, the light power off for few seconds, then power on again... It looks like the 6v regulator is heating too mutch? My light is 6V 0.5 A I ordered a 60v to 6v transformer and a SSR to switch it.

hi! Which version of the BMS App for android do you use? I'm using 3.04 from the play store, but I only have access to 1 screen with capacity and main voltage. I can't get the individual cells voltage, nor any of settings. Any help? Thanks. Edit: found the answer: the new version don't show...

Good news! I have the same problem, but I don't have a cyclanalyst. I will try to change the amps value on my controller, I'm waiting a new usb uart (burned the last one lol)

That's exactly my issue. It appends during acceleration, or during climbing. It's very annoying, and can be dangerous (no power when you just jump in a traffic circle...) :( I don't think it's coming from your motor because of burned sensors, mine is fine and never had sensors.