Recent content by fratto

Hi Christophe, As Valopallo already explained, my motor DO HAVE the 3 signals from the motor hall sensors , which serves as feedback for the rotor position, necessary condition if you want to run the open source firmware. It is the connector labelled "motor-hall sensors" in this picture: You...

I would say the programming interface is THE OTHER ONE labelled "SOFT" in your second photo . You can also check with a digital multimeter if your programming connector has the usual pin order ( from left to right, as showed in your photogragh ) : 5V, SWIM , GND, RST. For more info...

Hi all, I want to thank specially Stancecoke for helping me last time, and also my congrats to Xnyle for his BlueOSECApp , the info it gives is really great!!! :!: Sorry for bothering again, but it seems I must ask for your help yet another time... All went really good after replacing my...

Hello Christophe, I'm not an expert on the matter, but your case is very similar to mine, so I can tell you my own experience : I have installed the @Stancecoke BMSBattery_S_controllers_firmware on my KT ZWS motor controller with a KT LCD-3 display and also used it with the Android App (...

Hi, I'm new in the forum. Congratulations for all the people involved in developing this great FOS Firmware project !!! :bigthumb: I've been reading and learning all that I could from these web sites: https://opensourceebikefirmware.bitbucket.io/ https://github.com/hurzhurz/tsdz2/...